Page 1 of 1
the sweet taste in threadlock is cyanide (very poisonous)
Posted: Sat Jul 15, 2006 10:23 pm
by dr16143
Howdy All, a few post back the guys where talking about Blue Loctite/theadlocker tasting like
sugar. The tube states that we are to avoid getting on our skin or eating it. That is because is
contains Cyanide compunds. That is the sweet taste. It is not a good idea to injust this stuff.
A lump the size of a matchhead is supposed to be enough to kill an adult. Motorcycling has
enough dangers without adding new ones. Guess I should say "Don't drink the Kool-Aid !!!!"
Regards, Tim
the sweet taste in threadlock is cyanide (very poisonous)
Posted: Sat Jul 15, 2006 11:04 pm
by Tengai Mark Van Horn
At 3:22 AM +0000 7/16/06, dr16143 wrote:
>Howdy All, a few post back the guys where talking about Blue
>Loctite/theadlocker tasting like
>sugar. The tube states that we are to avoid getting on our skin or
>eating it. That is because is
>contains Cyanide compunds. That is the sweet taste. It is not a good
>idea to injust this stuff.
>A lump the size of a matchhead is supposed to be enough to kill an
>adult. Motorcycling has
>enough dangers without adding new ones. Guess I should say "Don't
>drink the Kool-Aid !!!!"
>Regards, Tim
Uh.... the mere presence of a nitrile group in a compound does not
indicate significant formation of toxic cyanide ion.
Mark
the sweet taste in threadlock is cyanide (very poisonous)
Posted: Sat Jul 15, 2006 11:20 pm
by a14@att.net
> Uh.... the mere presence of a nitrile group in a compound does not
> indicate significant formation of toxic cyanide ion.
>
> Mark
>
The xB ion is more toxic than the xA ion.
Walt
bolt dimensions
Posted: Sun Jul 16, 2006 2:21 am
by Ernie Campbell
Ebay has two nice kits, one for the motor and one for the rest. I did not like the compressed oatmeal screws, so i seeked screws elswhere (No it Wasnt A Whore Or A Hooker). Ebay- search KLR. Can you say KLR?
Ernie Campbell
----- Original Message -----
From: weric.caldwell
To:
DSN_KLR650@yahoogroups.com
Sent: Saturday, July 15, 2006 10:37 PM
Subject: [DSN_KLR650] Bolt dimensions
Where can I obtain the bolt specs/dimensions (ie; grade, size, pitch,
length) without taking each one out and measuring? I would like to
replace the majority with stainless and possibly a different head
configuration.
Thanks
[Non-text portions of this message have been removed]