Wilsons Sandbox

I recently purchased a 2006 650klr. I drove per recommended break in procedures & had the first service done (500 mile). I now have 1800 miles & the bike seems to surge a little when I try to maintain an easy cruise speed. Any idea what may be going on & what could be the possible fix? Thanks in advance for help!

This subject came up a couple of weeks ago and one of the suggested solutions was to check the chain tension. Worth a look DC tghn1 wrote:

>I recently purchased a 2006 650klr. I drove per recommended break in >procedures & had the first service done (500 mile). I now have 1800 >miles & the bike seems to surge a little when I try to maintain an >easy cruise speed. Any idea what may be going on & what could be the >possible fix? > > >

[Non-text portions of this message have been removed]

And open the pilot screw on the carb one full turn. That will help a little. The KLR runs real lean, and the cooler weather makes it worse. Rick A17 David Critchley wrote: This subject came up a couple of weeks ago and one of the suggested solutions was to check the chain tension. Worth a look DC tghn1 wrote:

>I recently purchased a 2006 650klr. I drove per recommended break in >procedures & had the first service done (500 mile). I now have 1800 >miles & the bike seems to surge a little when I try to maintain an >easy cruise speed. Any idea what may be going on & what could be the >possible fix? > > >

[Non-text portions of this message have been removed] Archive Quicksearch at: http://www.angelfire.com/ut/moab/klr650_data_search.html List sponsored by Dual Sport News at: www.dualsportnews.com List FAQ courtesy of Chris Krok at: www.bigcee.com/klr650faq.html Yahoo! Groups Links --------------------------------- Yahoo! FareChase - Search multiple travel sites in one click. [Non-text portions of this message have been removed]

went on some further reading here and seems like they found a replacement : http://www.multisurfacemotorcycling.com/articles/fft080104.htm kawa part no: 92049-016 aka OIL SEAL,RV37129.5 has anyone tried em out yet? i have to rebuild the top end if i want to change them right? clint --- In DSN_KLR650@yahoogroups.com, "clint lee jin yew" wrote:

> > hi dudes, i read this the other day and was wondering if anyone

came up

> with the types of valve seals which we can use to replace them

stock

> ones coz they suck dino juice. > > clint >