Wilsons Sandbox

Posted: **Thu Feb 03, 2005 1:56 pm**

I have a 2000 klr and the plastic is staring to look a little faded and worn. I'd like to change the plastic (and tank if need be) to a C model. Anyone know where I can get it, and also any problems I might have in doing so? Thanks Kurts

Posted: **Fri Feb 04, 2005 8:18 am**

At 05:02 AM 2/4/2005, you wrote:

>> From: matteeanne@... [mailto:matteeanne@...] >> And most important, go to the bike as soon as >> possible, wrenchs screwdrivers allen wrenches in hand >> and tighten every nut bolt and screw on the bike.

I have to ask. Since the owners manual does not have the torque spec's, how does one know how tight the bolts, nuts, etc... are supposed to be? I ordered the shop manuals but until they come in I'm hesitant to start putting lock-tight on anything other than the fasteners that hold the body panels on (which I have already done). Jon...

Wilsons Sandbox

checking bolts on new bike [was: new a19]

new plastic

checking bolts on new bike [was: new a19]