Wilsons Sandbox

I know that instead of replacing the needle with an adjustable type that you can use shims, but I can't remember what the benefit of raising the needle is... and how much it will affect my AZ emmissions test...? ~Eric AZ --- In DSN_klr650@yahoogroups.com, "Randy Shultz" wrote:

> > --- In DSN_klr650@yahoogroups.com, "klr6501995"

wrote:

> > > > no. removing is not required. > > Thanks for the reply. To anyone who has installed the KLX

adjustable

> needle mentioned in the FAQ, where did you find the best clip > position was for the KLR? I understand that it can vary bike to > bike. I'm just looking for the best place to start. My bike is > stock in terms of air/exhaust. > > Randy

We're slated to be in Cali, Colombia Dec. 25, then on down the coast and over to Ushuaia. Looking for other adventurers for magazine article. If you're out there drop us a note, maybe we can connect. www.ultimategloberide.com __________________________________ Do you Yahoo!? Read only the mail you want - Yahoo! Mail SpamGuard. http://promotions.yahoo.com/new_mail

--- In DSN_klr650@yahoogroups.com, Globeridergreg wrote:

> We're slated to be in Cali, Colombia Dec. 25, then on > down the coast and over to Ushuaia. Looking for other > adventurers for magazine article. If you're out there > drop us a note, maybe we can connect. www.ultimategloberide.com >

check out www.travelcommentary.com. Chris and Mark are probably in Mexico City by now, and will there for a while. All the best, Mike