Page 1 of 1
stock carb jet size?
Posted: Thu Jul 08, 2004 11:22 am
by JRC
My bike is still acting like it's running lean, so I'll probably dig
into the carb this weekend.
Because the carb was worked on by one of the previous owners (pilot
screw plug was drilled out), I don't know what else has been done to
the carb.
Can anyone tell me the stock jet and needle size? I want to
ascertain if any other mods have been done to the jets and needle or
if these items are stock.
Thanks
Jim
'99 KLR 650
'01 Intruder LC1500
stock carb jet size?
Posted: Thu Jul 08, 2004 1:34 pm
by rsanders30117
If the carburetor needle has notches (which is good), then it's not
OEM. If no notches, then it's OEM & the jet is probably standard. A
previous owner may have simply tweaked the idle mixture.
Be care with the diaphragm. Let it air out over night to shrink
back to normal size & use a smear of grease to hold it in place while
installing the cap.
--- In
DSN_klr650@yahoogroups.com, "JRC" wrote:
> My bike is still acting like it's running lean, so I'll probably
dig
> into the carb this weekend.
> Because the carb was worked on by one of the previous owners (pilot
> screw plug was drilled out), I don't know what else has been done
to
> the carb.
> Can anyone tell me the stock jet and needle size? I want to
> ascertain if any other mods have been done to the jets and needle
or
> if these items are stock.
>
> Thanks
>
> Jim
>
> '99 KLR 650
> '01 Intruder LC1500
its me
Posted: Thu Jul 08, 2004 7:25 pm
by rdbeer@psy.ucsd.edu
your document is not good
[Non-text portions of this message have been removed]