Wilsons Sandbox

Posted: **Wed Jun 09, 2004 1:19 pm**

I have recently purchased a 91 Tengai that is in need of front springs. Anybody have any suggestions on where I can get aftermarket springs? Thanks Jeff Dale Lincoln, NE

Posted: **Wed Jun 09, 2004 2:49 pm**

For those who added aftermarket aluminum bars, I assume you drilled the hole on the left side for the post on the switch housing. Anything special about drilling a hole in an aluminum bar? Randy

Posted: **Wed Jun 09, 2004 2:54 pm**

> For those who added aftermarket aluminum bars, I assume you drilled > the hole on the left side for the post on the switch housing. > Anything special about drilling a hole in an aluminum bar?

I filed off the knob on the switch housing. -Lujo [Non-text portions of this message have been removed]

Wilsons Sandbox

tengai front springs

tengai front springs

drilling aluminum bars

drilling aluminum bars