front sprocket.....question
Posted: Wed Dec 03, 2003 11:17 am
hey folks been awhile since I was on this site.......last night I
pulled my front sprocket off my klr cause I think that I have a
output shaft seal leaking...can I remove and replace this seal
easily? w/ puller etc.I also noticed that the sprocket has rubber
extruded through the holes in it is this rubber seal nessesary to
keep the output shaft from leaking? ( mine is no good anymore is
falling apart)...any infogreatly appreciated...< I am to damn cheap
to buy a manual>..........jimmy....eugene,oregon.......