Page 1 of 1
torque settings
Posted: Tue Jul 02, 2002 10:48 am
by klryyz
Quick question: I borrowed a torque wrench do finish my valve
adjustment job and I noticed it is in inch-lbs but the Kawi manual
has everything listed in ft-lbs. How do I convert?
Also, in that great web page about how to adjust the valves there are
two paths you can take when reassembling. One involves fiddling with
the balancer and the other does not. I would like to avoid fiddling
with the balancer - is it O.K. to do this? Has anyone else taken the
easier route and not experienced any problems?
John in T.O. A11
torque settings
Posted: Tue Jul 02, 2002 10:58 am
by Thomas J Komjathy
1 Foot pound = 12 inch pounds. Multiply or divide as ness. Example; 13 FP x
12 = 156 IP
Tom K.
torque settings
Posted: Tue May 27, 2003 8:54 pm
by Randy
I recently purchased a set of lowering links from another member
here. I pick up my KLR 650 next week and will lower it as soon as I
get it as it is sort of a surprise for my 15 year old. What are the
torque settings for the bolts holding the links and also for the
fork tubes? How much should I raise the tubes?
u-nut kit
Posted: Wed May 28, 2003 9:24 am
by Chris Krok
Thanks! But the kit won't do anything for the peni/grommet joint. (Is
that why you needed one?)
Krokko
--
Dr. J. Christopher Krok
John Lucas Adaptive Wind Tunnel
Caltech MS 205-45, Pasadena, CA 91125