Wilsons Sandbox

Posted: **Sat Aug 05, 2000 6:39 pm**

How small of an O ring do you need. Looking at my Napa assortment, they go down to 1/8 ID -1/4 OD out of 1/16 stock. Have you talked to the gus at your local parts store? Don KLR A13 "Salad Shooter" 73' TS185

Posted: **Sun Aug 06, 2000 7:40 am**

Barry (BCDIRECT@...) wrote: [fiddly little carby O-ring search]

> Does anyone have access to these two O-ring that could help me out?

Sounds like you need to go genuine. Mister_T

Posted: **Sun Aug 06, 2000 6:14 pm**

-----Original Message----- From: Mike Awesome [mailto:mpasuit@...] Sent: Sunday, August 06, 2000 12:10 PM To: DSN_klr650@egroups.com Subject: [DSN_klr650] bashing the moose cont I surmise a log hit the bash

> plate which offered no protection for the drain plug. > Has anybody rigged something to protect the drain plug ? > > Mike very plugged Awesome > A1klr650

Mike Your drain plug must be below the plate. I was going to heli-arc a ridge on either side of the drain hole on my plate, but the nut doesn't protrude. I've dead centered lots of rocks without any problems. Maybe you can shim yours down on the drain hole end. Good luck DAngus A-11

Wilsons Sandbox

[dsn_klr650] bashing the moose cont

[dsn_klr650] o-ring help

[dsn_klr650] o-ring help

[dsn_klr650] bashing the moose cont