Wilsons Sandbox

I installed a inline fuel filter. It's a FRAM part # G1. I bought it at an automotive store this morning. Its about 1.5 in (38mm) diameter by 2 in long (51mm) and made of see thru clear plastic so I can see the dirt. It cost me $2.99 USA. It's a tight fit but I think it will work. I didn't remove anything to install it. Just guessed where the line should be cut and did it. It works ok but I think the line from the filter to the carb has too tight of a bend. The bike runs OK with no fuel starvation on short runs (about 2 miles), so I don't think I pinched the rubber line closed. If I had removed some of the things in the way I could have better measured where to cut the line and I wouldn't have to worry about a pinched fuel line. ________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com