Wilsons Sandbox

Posted: **Sat Jul 29, 2000 8:22 pm**

Slime makes a series of polyurethane strips for bicycles, meant to fit between tire and tube to prevent flats. Has anyone tried these (or anything similar) on their motorycle tires? Dreas

Posted: **Sun Jul 30, 2000 9:05 am**

steve6018@... wrote: [screw-on-the-loose story deleted]

> Does anybody know what the caps on the camshaft are torqued too?

104in-lbs (i.e. not much)

> Does anybody know what the big nut holding the magneto hub is torqued > too?

130ft-lbs An interesting little note in my 650A manual says: "Replace the mageneto flywheel bolt with a new one. This bolt is required to replace if it has been tightened once to the specified torque." Tightening procedure of the magneto flywheel bolt is the following. Tighten the magneto flywheel bolt to 120N-m (12.0 kg-m, 87 ft-lbs) of torque. Do not overtighten it now. Loosen the bolt and then tighten again to the same torque (above). Finally, tighten the bolt to the specified torque." I don't know of anyone who has actually replaced the bolt as per manual spec. Mister_T

Wilsons Sandbox

[dsn_klr650] valve shim problemmmmmmmmmmzzzzzzzzzzzzzzzz

nklr: slime liner

[dsn_klr650] valve shim problemmmmmmmmmmzzzzzzzzzzzzzzzz