[dsn_klr650] coasting enricher

[Ted Palmer]

Barry wrote: [...]

> On the left side of the card you remove two screws- > This removes the hold down plate and the enricher cover- > Then come the spring- > Then the rubber/metal T-shaped diafram jiggi- > Is the O-ring suppose to be at the bottom of this T-shaped item?

The only O-ring there that I know about around there goes on the carb body in a recess next to the hole where the diaphragm fits. The O-ring seals the join of the passageway that feeds the vacuum to the left side of the diaphragm. If you look on the inside of the cover of the enricher, you should be able to see how the passage follows the outside of the cover. That's how the diaphragm gets sucked against the spring. Mister_T