Wilsons Sandbox

 

----- Original Message ----- [b]From:[/b] BCDIRECT@... [b]To:[/b] DSN_klr650@egroups.com [b]Sent:[/b] Monday, July 24, 2000 8:32 PM [b]Subject:[/b] [DSN_klr650] Dead on Road Update I did notice while reassembling the choke/enericher cable that the plastic nut that screws into the card was cracked part way.  [color=#000000]I got out my trusty super glue and did the best patch job I could.  DOes anyone know if I can order one of these?  And where? [/color]   [b]I happen to have one in stock.[/b]   Also does anyone have any good suggestions as to how to tighten/loosen this darn thing?    [b]Very carefully. [/b]   Could they find a worse place to put it?   [b]I doubt it.  Maybe they could.[/b]   [b]Fred[/b]

left side, just cut off the end of the grip. right side, what i do loosen up the throttle assembly a little, slide it out (right) like an inch or so, then take a hack saw and hack off like 1/8" from the end of the throttle sleeve so it's open on the end. it's worked on all my dirtbikes so far. _pete -----Original Message----- From: Tarnowski Paul [mailto:prospectt@...] Sent: Wednesday, July 26, 2000 10:28 AM To: DSN_klr650@egroups.com Subject: [DSN_klr650] Acerbis Rally Brush handguards Hi, I'd like to know if anyone installed a pair of Acerbis Rally Brush handguards on the stock handlebars of their KLR. I just ordered a pair of these and I'm wondering if I'm going to have to do some cutting in order to get them to fit properly.. ________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com Visit the KLR650 archives at http://www.listquest.com/lq/search.html?ln=klr650 Support Dual Sport News... dsneditor@... Let's keep this list SPAM free! Visit our site at http://www.egroups.com/group/DSN_klr650 To unsubscribe from this group, send an email to: DSN_klr650-unsubscribe@egroups.com