Page 1 of 1
torque spec for 'stat housing?
Posted: Tue Jul 18, 2000 9:15 pm
by wileyE_@excite.com
Anyone know the spec for the 3 bolts that hold the thermostat cover
on? Have to replace the 'stat as the rubber gasket is developing a
leak. Thinkin about just putting some sealant on the cover flange
till the part comes in, what-ya all think?
torque spec for 'stat housing?
Posted: Tue Jul 18, 2000 11:54 pm
by wileyE_@excite.com
Thanks for the quick reply John, but I did a quicker reassembly. Set
em at 69inlbs (a generic spec for a 6mm on an old chart I have).
Lucky nothing snapped or stripped, guess I could run out and reset it
before the locktight sets up. cheers wE
-- In
DSN_klr650@egroups.com, John Lyon wrote:
> 56 inch pounds for the thermostat cap bolts
>
> John
>
> On Wed, 19 Jul 2000 02:15:00 -0000, wileyE_@e... wrote:
>
> Anyone know the spec for the 3 bolts that hold the thermostat
cover
> on? Have to replace the 'stat as the rubber gasket is developing
a
> leak. Thinkin about just putting some sealant on the cover flange
> till the part comes in, what-ya all think?
>
>
>
>
>
> _______________________________________________________
> Say Bye to Slow Internet!
>
http://www.home.com/xinbox/signup.html
honda nx650 (nklr)
Posted: Wed Jul 19, 2000 12:28 am
by Jim Hyman
Kevin,
A quick check of major search engines (Northern Light, Excite,
Alta Vista) yielded 800-900 hits. Many of the sites were in
Australia and England & included several NX650 groups.
You may need some translation software (G!).
Happy searching.
Professor A9 Federal Way, Wa [USA]
--------------------------
--- "Kevin" wrote:
> Anyone have an info or links to info on the NX650?
> Maybe reliability or bike specs?