shifter angle adjustment
Posted: Mon Jul 17, 2000 2:02 pm
I installed an IMS shifter on my '96 KLR 650 and it is too high for me.
If I lower it one spline then the shifter lever hits the frame. Is there
a way to rotate the shifter 'axle' from the far side for fine adjustment
or does it have a similar splined end that would rotate the same amount
as moving the lever itself.
At this point I'm going to switch back to the stocker and use the IMS as
a spare for the inevitable day that my stocker disintegrates. Allso, I
find the fat pad on the stocker more comfortable on my instep. Has
anyone tried a cable like the MSR brake saver to minimize bending in the
event of a fall down? Can the brake saver be used on the shifter as
well?
Thanks,
Todd Schroder
'96 KLR650