Page 1 of 1
installing rallypro handguards
Posted: Tue Jul 11, 2000 5:07 pm
by Weaver, Mark
i'm going to put on my rally pro handguard tonight. the left side should be
pretty straightforward, but are there any helpful hints for the right side?
do i need to remove any of the actual throttle bits, or just cut a hole in
the end of the grip? any special tools?
-mark weaver
hand guard - the simple aluminum bar type
Posted: Tue Jul 11, 2000 5:27 pm
by Dale_Johnson@ahm.honda.com
I bought an off brand aluminum bark buster at Malcom Smith Motorsprots in
Riverside Ca. I bought the least expensive one I could find, $35 It was a tight
squeeze, but i moved my clutch to the right a little and they fit good..( my
break was missing the ball from an earlier crash) I did manage to heat up a
stelleto and cut a hole in the stock guards and they fit perfect on the bark
busters, I was amazed at how acurate my eye balling measurements were.
Dale
A14