Are copper crush washers any better than aluminum, or does it not matter? Mark B2 A2>In a message dated Fri, 23 Jun 2000 12:46:45 AM Eastern Daylight >Time, "bmgecko" writes: > >washer, but with >a small gap that makes it "not a complete circle" and one end is slightly >higher than the other? > >Chris Astier > >> > > >The washer in question is a crush washer which is made of aluminum, >which is very soft, and forms a seal at the drain plug. Do not use >a lock washer or o-ring. The crush washer is thicker than a regular >washer. > >Gino
with> Is this possibly a lockwasher? Does it look like a regular washer, but
No way! A lock washer would gouge the sealing surfaces, and plus it wouldn't seal, as it has that split in it. A crush washer is simply made from a soft metal, copper or aluminum, so that it can be pressed tightly to the sealing surface and conform to any surface irregularities. Also note that the oil drain plug doesn't require hardly any torque, and the threads are in the soft(er) case material. Jeff> a small gap that makes it "not a complete circle" and one end is slightly > higher than the other? > > Chris Astier >
On the KLR I would say that it generally doesn't matter. Which one is softer and therefore seals with less applied force greatly depends on the alloy of each. The only instance where I could see choosing one over another is where you have to be concerned with corrosion, as aluminum generally withstands corrosion better, but the crush washer on the KLR doesn't stay on long enough between oil changes to matter in that regard. Jeff> > Are copper crush washers any better than aluminum, or does it not matter? > Mark > B2 > A2 > >
> Find the vacuum hose tee > that feeds a vacuum line to the front top of your carburetor (white). > Remove > that line, and the line running from the back of the fuel petcock. Now run > a > line from the front top of the carburetor (white) and connect it to the > rear > of your fuel petcock. > > Amen, and don't try to save a trip to the store by trying to plug the tee > instead of installing a new line. It may leak. How do I > know?........Bogdan
I usually buy my aluminum crush washers at the dealer. Recently they've been out of them. The parts guy said they're simply an aluminum washer you can get at any hardware store. Couldn't fine them at Ace. Was parts-person right? Bogdan> The washer in question is a crush washer which is made of aluminum, which > is very soft, and forms a seal at the drain plug. Do not use a lock > washer or o-ring. The crush washer is thicker than a regular washer. > > Gino >
Users browsing this forum: No registered users and 23 guests