Page 1 of 1
[dsn_klr650] axle nut
Posted: Sun Jun 11, 2000 7:34 am
by Ted Palmer
InWoods13@... wrote:
>
> Anybody have the torque value for the front axle nut? Yes I really need to
> get a shop manual, it's next on list. Thanks in advance.
58 ft-lbs
Mister_T
[dsn_klr650] axle nut
Posted: Sun Jun 11, 2000 7:56 am
by InWoods13@aol.com
In a message dated 6/11/00 8:35:13 AM Eastern Daylight Time,
tedp@... writes:
> get a shop manual, it's next on list. Thanks in advance.
58 ft-lbs
Mister_T >>
Thank you & those that replied off list.
I'm slowly conquering my phobia of working on my own four stroke. I'm fixing
to head over to a friends place to install my lowering links & front disc
protector. Using his engine lift to raise the KLR in place of the live oak in
my back yard should make things a breeze.
Construction has begun on a Big work bench, going to order a shop manual on
Monday & trying to buy quality tools only. All best
Scott(determined to lower his cg)
A14 "Thunderdog"
Sorrento
my links
Posted: Sun Jun 11, 2000 10:43 am
by Verle Nelson
> From:
>
> The Quality Engine R&D links that I ordered from Dualstar appear to be
> aluminum and measure 5 1/2 inches from center to center. They appear to be
> the only size that Quality Engine R&D offer.
> Going to be installing them abit later today and am pumped!
> Really hoping that these make the beast abit more manageable in the dirt.
All
> best
Thanks. I have those links (got them from Fred) and like them (see archives)
but just a half inch more clearance would be nice. I was wondering who the
person was that offered different links in two sizes.
Verle Nelson
Cedaredge, CO