Wilsons Sandbox

Posted: **Fri Jun 09, 2000 1:53 pm**

Joe, I've had the Kawi tall windshield for 5 months now and am very pleased with it. I do like another lister said and put the plasic nuts on backwards (flat side to screen). I was on the highway with a ninja 600 last night for about 5 miles at 110 mph indicated and all I had to do was squat down a little to get inside the envelope. I haven't had to tighten the nuts at all since the last installation about a month ago. Can't say much to the brush guard issue. Depends on where you ride. I run acerbis rally pros with spoilers and love them. They keep the wind off better than the stockers and have saved my hands a couple times in the woods. Jim Jackson II A13 - South Carolina ________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com

Posted: **Fri Jun 09, 2000 2:14 pm**

I had a similar experience around that speed. It turned out that I was low on fuel (just went to reserve) and it was hot out which in combination created too much pressure in the tank and the bike was starving for fuel at higher speeds. Once I was off the highway, it did fine. When I parked it, I opened the gas tank and it was like opening a coke can that's been shaken up! I filled the tank and took it back out, no problems. Just a thought... The solution to that problem is to clean out your gas tank cap labyrinth vent with some carb cleaner spray. Don't use compressed air, as it can damage it. You tank needs to vent properly to allow air to enter as gas leaves (Volumetric flow rate problem). Jeff

Wilsons Sandbox

[dsn_klr650] help needed

[dsn_klr650] tall windshield

[dsn_klr650] help needed