Page 1 of 1
[dsn_klr650] part needed
Posted: Thu Jun 08, 2000 12:26 pm
by TLrydr@aol.com
In a message dated 6/8/00 10:26:35 AM EST, cyr_ken@... writes:
<< I'm scheduled to leave for Colorado for
the HSTA STAR2000 rally. I called Kawasaki customer
service and they confirmed the shipping date >>
When and where is the HSTA,
Mike
creep
Posted: Thu Jun 08, 2000 1:52 pm
by Glenn
I have had this feeling that my A14 is creeping when I
put it into gear. I verified this by leveraging the
rear wheel of off the ground via the side stand and
putting the bike in 1st gear with the clutch lever
pulled all the way to the bar. The bike wheel spins.
Not just a slow rotation but at a fairly good speed.
If I am stopped it doesn't move the bike so it's not
that fast. I tried it in 2nd and got the same results
(of course the wheel spun faster).
I tried adjusting the clutch at the lever but it still
does it. Is this normal for a KLR or should I try
adjusting the cable down at the crankcase? I don't
remember my other bikes ever doing this, the wheel may
have slowly rotated around but not like the KLR does.
I had my A14 in for it's initial service about a week
and a half ago. It now has 900 miles on it. Could it
be the oil the dealer put in? Not sure what weight
they used.
Thanks.
Glenn
__________________________________________________
Do You Yahoo!?
Yahoo! Photos -- now, 100 FREE prints!
http://photos.yahoo.com