Page 1 of 1

heat guard

Posted: Wed May 17, 2000 8:20 pm
by Darrel & Deanna
On the subject of the heat guard...for those whose heat guard screws can still be removed, I recommend dressing the screws with ant-sieze com- pound. The screws tend to weld themselves to the header pipe. Darrel A12 ************************* It has occured to me that if something falls off and the bike is still going, then this something shouldn't be on the bike in the first place. After a while, the KLR should painlessly reach the enviable 250 lbs.... (Just kidding. Without the heat guard, the heat reaching the leg is quite fantastic.) Janek KLR-650 '00 Orange County, CA