[dsn_klr650] remote fuse block
Posted: Fri May 12, 2000 3:20 pm
Subject: [DSN_klr650] Re: Remote Fuse Block
Thank you.> Arne, > > VERY NICE JOB!
Yes... it is stranded.> 12 guage wire? fine (i hope it's stranded wire, not solid > core).
Good point. I'll cut off the yellow plastic stuff - solder the connection - and heat shrink them. I've got about 40' of the stuff.> Crimped electrical connector on wire ends? OK if soldered. > I prefer heat-shrink tubing on all soldered connections, > the connections won't separate due to vibration.
The fuse in the block itself will not serve this purpose? No, I guess it won't, as it falls in-line "after" the wire... I don't mind over-kill (to an extent). Putting a master fuse in line might be a good idea. Thanks for the feed-back! Arne> My only concern with the long length of 12 guage wire is > that there doesn't appear to be any protection against an > electrical short of this wire, unless you have a master > fuse or circuit breaker near the battery. This may seem > like overkill, but under the wrong circumstances ...