throttle lift hole drill bit size?
Posted: Wed Apr 19, 2000 9:29 am
Kurt,
The topic of drilling out the Throttle lift hole (in the slide) has been
discussed before. However, in the old archives, I could not find the
drill bit size mentioned any where. What is the size of the bit which
is supplied in the Dynojet kit. I'd like a more responsive throttle. I
don't need to rejet. I just need to keep my K&N air filter clean.
Please reply all & thank you in advance,
--
Jeff, NM, '99 KLR650, IBA/SS1000
http://www.flash.net/~n5ujj - Down Home Page
http://www.flash.net/~n5ujj/hamstuff - HAM It UP Page
http://www.biker.net/klark/ - My KLR Page