[dsn_klr650] swingarm bolt removal- help
Posted: Sat Apr 08, 2000 6:33 pm
Hi Larry,
I just performed the lubbing thing myself . I have an A8 and extracting the
bolt has no tricks except the use of a heavy rubber mallet, I also supported
the swing arm from below with a car jack.
Now to actually remove the swing arm from the frame you need to loosen the
engine support bolt that is placed exactly behind the swing arm. Don't
forget to take care of the rear caliper as you remove the swing arm. Pay
special attention to place the drive chain in it's correct position as you
reasemble the swing arm. Tighten every bolt to spec.
Good Luck
Juan
----- Original Message ----- From: To: <> Sent: Friday, April 07, 2000 8:49 PM Subject: [DSN_klr650] Swingarm bolt removal- help > Serviced the unitrac, no problem, but tried to remove swingarm, nut came off, > bolt turns freely but will not slide out, is there a locking mechanism or a > trick to getting bolt out. > > Thanks > Larry > > ------------------------------------------------------------------------ > @Backup- Protect and Access your data any time, any where on the net. > Try @Backup FREE and recieve 300 points from mypoints.com Install now: > http://click.egroups.com/1/2345/3/_/_/_/955158555/ > ------------------------------------------------------------------------ > > Visit the KLR650 archives at > http://www.listquest.com/lq/search.html?ln=klr650 > Support Dual Sport News... dsneditor@... > Let's keep this list SPAM free! > > Visit our site at http://www.egroups.com/group/DSN_klr650 > To unsubscribe from this group, send an email to: > DSN_klr650-unsubscribe@egroups.com > >