relay wiring

[aches@deltech.net]

Dude, If the scoot is vibrating That bad, you have a problem. Balancer out of sync or ??? Needs to be checked to be sure. Heck., mine don't vibrate that much more than my Beemer R11RA. And., have not had a bike that doesn't buzz the rear view mirrors in so long that I forgot what that is;. Just pull in the clutch and look then or put your hand on the mirror to dampen it. Not a problem. -- Best Regards & Happy Trails Andy Chesley @ 57 and ticking Y2KLR650 @ 6.4K sMiles 97 R11RA (Amiga) @ 16K Miles So Many Roads, So Little Time http://members.deltech.net/aches/

[TLrydr@aol.com]

Mine started vibrating more when i installed the moose bash plate and Acerbis hand guards, Beats me why, Any way when i want smooth i ride the SE1500, KLR Y2K at 6,500 miles and going strong.................... Mike..

[Mark Weaver]

i used 14ga, because it said it was good up to 15 amps, or something close to that. 12 gauge is certainly plenty. mw

> -----Original Message----- > From: michael.scherer@... [mailto:michael.scherer@...] > Sent: Tuesday, November 07, 2000 11:57 AM > To: DSN_klr650@egroups.com > Subject: Re: [DSN_klr650] Re: Relay wiring > > > > Thanks. One more question. Would 12 gauge wire be sufficient or > too heavy > for the Hot Grips and a 4 amp fuse? > > Biker Mike > > > > > Visit the KLR650 archives at > http://www.listquest.com/lq/search.html?ln=klr650 > Support Dual Sport News... dsneditor@... > Let's keep this list SPAM free! > > Visit our site at http://www.egroups.com/group/DSN_klr650 > To unsubscribe from this group, send an email to: > DSN_klr650-unsubscribe@egroups.com > > >