final drive chain clearance

DSN_KLR650
Post Reply
Steven van Twuyver
Posts: 151
Joined: Thu Apr 06, 2000 10:49 pm

final drive chain clearance

Post by Steven van Twuyver » Mon Aug 28, 2000 10:49 pm

My master link clip dissapeared on my trip and it was oriented correctly. I believe my clip came off because I pressed the master link plate on too tight. This made it so that there is no resistance against the clip. It fell of on the road - not off road riding. I installed the next one and used a screwdriver to wedge the masterlink plate apart for a tight fit against the clip. -svt- Original Message: ============== I have been watching and checking my chain and masterlink very closely since I dropped the chain. I'm noticing that the tips of the masterlink are showing some wear from apparently brushing the bolt occasionally. The masterlink ends protrude out just a fraction farther than the other permanent rivets. So now I'm starting to get worried about chain problems again. Does anyone have any similar observations? And has anyone done any modifications to address the chain clearance problems? Or should I just not be concerned as long as the clip is installed correctly? Any help or suggestions would be greatly appreciated. -Dave Kleber

Post Reply

Who is online

Users browsing this forum: No registered users and 22 guests