[dsn_klr650] throttle lift hole drill bit size?

[Dust]

Any pics? How well did they work on the road? Survive off road very well? Thanks, Dust A14 Man with Big Grin

--- In DSN_klr650@egroups.com, Tom Simpson wrote: > > > Dust wrote: > > > I remember reading about someone buying a headlight with higher > > output from Walmart or a similar store on the list, but am too lazy > > (and ignorant about the list) to search the archives. > > > > Part number maybe?? > > Not higher output, but I did outfit my bike with a pair of 37.5 W > driving lights for additional lighting. Worked fine, but proved to be > surperfluous to my needs. > > -Tom > '96 KLR 650

[Dust]

YOU THE MAN!!! This is exactly what I was wanting. Those "blue" lights attract such attention...less likely to get plowed! Much thanks, Dust A14 Man with BIGGER Grin P.S. how sad that I am actually excited about purchasing a light bulb. (sigh)

--- In DSN_klr650@egroups.com, John Lyon wrote: > Dust, > > I use a SYLVANIA 9003 CB bulb. It is a whiter light and IMO is much better > than the stock H4 bulb. Another plus is it has the same rating as the stock > bulb.

[Dash Weeks]

At 08:29 AM 4/19/00 -0600, Jeff wrote:

>Kurt, >The topic of drilling out the Throttle lift hole (in the slide) has been >discussed before. However, in the old archives, I could not find the >drill bit size mentioned any where. What is the size of the bit which >is supplied in the Dynojet kit. I'd like a more responsive throttle. I >don't need to rejet. I just need to keep my K&N air filter clean. > >Please reply all & thank you in advance, >-- >Jeff, NM, '99 KLR650, IBA/SS1000 >http://www.flash.net/~n5ujj - Down Home Page >http://www.flash.net/~n5ujj/hamstuff - HAM It UP Page >http://www.biker.net/klark/ - My KLR Page

#30 LaterZ Dash A2 - Da' Bomb No Longer Crashing for Beer Will wheelie for Virgin Oil