Re: Just getting started and may have found an issue.

[pyxis738]

Attachments :

1. [url=file:///C:\Users\thorstenlemke\AppData\Local\PG Offline 4\Attachments\cadintoshmac\WithoutArc.png]WithoutArc.png[/url]

1. [url=file:///C:\Users\thorstenlemke\AppData\Local\PG Offline 4\Attachments\cadintoshmac\WithArc.png]WithArc.png[/url]

Using 7.5.4 on MacBookPro. In the process of creating a new CAD and am losing a drawn arc when I zoom in a bit. Attached are two small screenshots, both showing the zoom factor. One, at zoom 141%, the arc shows just fine. The Second, at zoom 155% the arc is gone. I have tried, by increasing the ink width to make it show, but that does not work. Any ideas? I have also saved the file as DXF, then re-imported, all to no avail. Thanks. Al

[thorstenlemke]

Hello,
please e-mail the cad drawing zipped to lemke@lemkesoft.de
Thorsten

[Attachment(s) from aszy@mac.com [cadintoshmac] included below]
Using 7.5.4 on MacBookPro. In the process of creating a new CAD and am losing a drawn arc when I zoom in a bit. Attached are two small screenshots, both showing the zoom factor. One, at zoom 141%, the arc shows just fine. The Second, at zoom 155% the arc is gone. I have tried, by increasing the ink width to make it show, but that does not work. Any ideas? I have also saved the file as DXF, then re-imported, all to no avail. Thanks. Al
Attachment(s) from aszy@mac.com [cadintoshmac] | View attachments on the web 2 of 2 Photo(s)WithArc.pngWithoutArc.pngPosted by: aszy@mac.com

[Al Szymanski]

Done.