Wilsons Sandbox

Hello,
I use the following settings:

Parameter - Drawing: A4 vertical
File - Page Format - Standard: A4 vertical

If I define an area via "define with page" this area is clearly smaller than the defined page.
I figured that if both, drawing and page is set to A4 that the corresponding area defined by
the page should have exactly the same size.

What do I do wrong?

Attachments :Re: [cadintoshmac] Problem with page size and printing Hello,

The print area shows normally the printable area.

Thorsten

Von: "bernd.bieker"
Antworten an:
Datum: Sat, 21 Feb 2009 08:48:19 -0000
An:
Betreff: [cadintoshmac] Problem with page size and printing

 
 

Hello,
I use the following settings:

Parameter - Drawing: A4 vertical
File - Page Format - Standard: A4 vertical

If I define an area via "define with page" this area is clearly smaller than the defined page.
I figured that if both, drawing and page is set to A4 that the corresponding area defined by
the page should have exactly the same size.

What do I do wrong?

 
      
     
.