Wilsons Sandbox

Attachments :At 2008-11-17 03:11 +0000 aquaticdoc@ymail.com wrote:

>Having tried unsuccessfully for the last half-hour to join the Yahoo
>group, with failure after
>failure, I am trying this method.
>
>I would like to create a to scale drawing at 1/4"-1'. In reading
>through the postings, I see
>others struggling with this, and I have tried all of the suggestions
>posted, but without
>success. I am drawing a large deck structure, 60' in width but with
>a lot of complexity. It
>should fit on a tabloid size page printed landscape, or I can use
>SuperA3/B if needed, but I'd
>like a scale drawing.
>
>Bruce Becker
>aquaticdoc@msn.com

Bruce - here attached is a demo drawing with just one 60-foot line on
it, scaled to 1/48 (options...drawing...scale of layer 1023 = 1/48),
and with the scaling of the area "all" (file...area...options...scale
= 1/48) also set to 1/48. The page setup of the "all" area is A3
landscape, and it prints on one sheet.

I think this realises what you are trying to do - but if not, please clarify.

Reply copied to CADintosh Yahoo! group for info, and file uploaded to
group archives.

regards

Rowland
--
| Wilma & Rowland Carson http://home.clara.net/rowil/
| ... that's Rowland with a 'w' ...

Thanx, I needed that file!