Page 1 of 1
Thanks Ray and Rowland
Posted: Wed Feb 07, 2007 12:46 am
by wyzardofdogz
Hey guys. I really appreciate your spending time to offer input and advice. Rowland, the link to PrintToPDF worked - most excellent! And I think my fill disappeared on the DXF's because on the CAD's I used greyscale, not hatching, to fill (it seems that hatching fill stays intact whereas greyscale doesn't). Is there a quick way of converting the grey-scale areas to hatching in my drawings?
Re: Thanks Ray and Rowland
Posted: Wed Feb 07, 2007 9:45 am
by Torsten Nilsson
Change one of them to hatching. Then use the tool "Apply all
attributes" to change the others. Thus you just have to click first
the changed one and then make one click on each of the other ones.
Torsten Nilsson
On 7 feb 2007, at 00.44, wyzardofdogz wrote:
> Hey guys. I really appreciate your spending time to offer input and
> advice. Rowland, the link to PrintToPDF worked - most excellent!
> And I think my fill disappeared on the DXF's because on the CAD's I
> used greyscale, not hatching, to fill (it seems that hatching fill
> stays intact whereas greyscale doesn't). Is there a quick way of
> converting the grey-scale areas to hatching in my drawings?
>
>
>
-------------------------------------------------------------------
Torsten Nilsson
totte@vasterbottensmuseum.se
Västerbottens museum 090/171886