Ivo - Thorsten may have already told you in a>I have problems with CADINTOSH
direct message, but in case not - there is a
separate list for CADintosh. Go to
to
subscribe and view archived messages etc.
I can see the problems you mention in the>problem Nr. 1: in enclosed drawing 1NP there
>appeared a line (running from 720/680 to
>8210/4770), which I cannot find in any layer and
>thus cannot be deleted ?!?!
>
>problem Nr. 2: very often I have problems when
>filling objects with color. Perimeter lines are
>correctly marked, but when finishing with "RET",
> the area is distorted (because marks do not
>appear in the respective corners). You can see
>the result on HARMONY (strange, it appears only
>with magnifications below 51% ???) and also in
>pdf HARMONY.
>
>This funny "chimney"comes from the lower left rectangle next to the door.
attached files, but haven't a solution to them. I
am interested to know the answers and hope this
thread will be continued on the CADintosh list. I
am copying this reply to the CADintosh list, and
will put your files into the files area there.
regards
Rowland
--
| Wilma & Rowland Carson
| ... that's Rowland with a 'w' ...